Tuesday, November 18, 2014

Real Plumbers - What does that mean?



Watch this video to find out.





Thank you,

Jay Bortnik
Journeyman Jay Plumbing
780-266-3939

Serving North Edmonton Homeowners
(who live in their own single-detached house)

Monday, November 10, 2014

Looking for the right plumbing materials


Plumbing is about the right plumber using the right tools to install the right materials.

Plumbing professionals should always be looking for better ways to do things.

That is why we attended CIPHEX 2014 - Plumbing & Heating Tradeshow (in Calgary) this past Wednesday/Thursday. (http://www.ciphexwest.ca/west2014/public/enter.aspx)

Along with all of the manufacturers' booths there were also seminars on plumbing topics.

I attended the seminar on water lines.  There is some contention within the industry with regards to "flow rates" (in the plumbing code) for different materials (copper, pex, etc).

What most people may not know is that flow rates for different materials vary dramatically.  So next time you think crimp pex (sold at home improvement stores) is just as good as the "other pex" or good old copper, think again.  That's why you may want to engage the services of a professionally trained plumber like Journeyman Jay.

 Picture of Journeyman Jay in front of the seminar room at CIPHEX 2014.


Picture of Journeyman Jay behind an interesting valve display.



Thank you,


Jay Bortnik
Journeyman Jay Plumbing
780-266-3939




Saturday, November 1, 2014

"Just" a New Bathroom - Finished

Before we start:

A big THANK YOU to our clients:  Troy & Cassandra.
We really appreciate being welcomed into your home for the week or so (rough-in and, later the finishing) this took to complete.

Photos of the NEW Bathroom project we just finished.





The fixtures in this new bathroom need venting (the pipe going into the ceiling) to operate properly.





 This is the flange that connects the toilet to the piping below.  It also holds the toilet to the floor.
In this case, the toilet flange is a little further from the wall to accommodate the "structural" floor joist that runs under the toilet.  Typically the toilet flange is about 12.5" to 13" off the back wall.




Water line for the toilet.
Wow.  That's it, right?  What about the hidden plumbing?  Where are we going to get the water?  Where is the waste going?




 Water line tubing and "soil" (term used when poop goes in it) pipe connected to WC (water closet) or toilet flange above.



 Waste pipe from LAV (bathroom sink) on left side which is connected to the bigger toilet pipe.
The toilet actually vents through the LAV pipe.



 We have to connect this new bathroom to the existing piping.  In this case we were blessed with a 3" pipe coming from the clothes washer.  But, this meant that we now had to vent a previously unvented fixture (clothes washer stand pipe).  Back in the day, they did this different than we do today.  Suffice to say we also re-piped the laundry so that our connection would conform to plumbing code.




 Lots of fun here.  Back in the dark ages (1950s, 60s, even 70s), plumbers used a lot of cast iron for drainage (and connected it with LEAD - dangerous).  Needless to say we had to make a few cuts into the cast iron to make our connection.  Well it wasn't that straightforward.  Here is what we found  where we were going to connect the new bathroom piping.  This pipe was only draining a clothes washer (for about 55 years).  So we cut out the whole horizontal pipe up to where it went vertical and replaced it with plastic (abs).  These cuts require special blades or special cutters (depending on preference or situation).



 Here is all the additional pipe we replaced (piled outside).



 This is what the attic looks like.  There's plumbing in the attic too??  Yes there is.  Remember the first picture with the vent pipe running up the wall.  It has to eventually connect to a pipe that leads outside.



 More venting we installed.  One pipe is from the laundry and the other is from the NEW bathroom.
We also had to cut cast iron to connect the NEW venting to the existing venting.



 Pipe must grade properly and must be properly supported (see metal strap with 2x4 board) holding pipe's grade (keeping it from sagging and filling with water - bad thing for a "dry vent")



 Here is our "green sticker" from the City of Edmonton Inspector.
He checked our piping and gave it his approval.



 Picture of the "rough-in" for the sink.





A roughed-in bathroom.
(It wouldn't look like much if you didn't see all that was done)


Installing shut-off valves for the water lines for the LAV.



 Braided supply tubes connecting the faucet to the water lines.




 The faucet.




 Installing tank to toilet bowl.




Cut those T-bolts.  
The mark of a neat plumber.




 The NEW bathroom.


To keep it simple we didn't show pictures of:

1.  Upsizing water lines  (from the water meter to the hot water tank to the other branch offs) to  
      accommodate new bathroom and meet plumbing code requirements for water flow..
     (While doing this, we had to also change the "very old" main shut-off as it started to leak after   
       being turned on and off)

2.  Re-piping the laundry.

So, as we mentioned in our previous BLOG posts  - There are many other variables when adding a new bathroom such as:  water line sizing, venting, and drainage capacity.  
This also doesn't even scratch the surface on fire safety, materials, confined spaces, dangerous substances (that might be encased in the building materials of your house).

As you can see, these bathrooms must be well thought out.

For a professional consultation (and possible estimate) give us a call at 780-266-3939.
These consultations and estimates differ from our normal consultations in that they involve lots of time and effort to solve plumbing challenges before anything is decided.  Therefore we charge a reasonable fee for this service. 


Thank you,

Jay Bortnik
Journeyman Jay Plumbing
780-266-3939